Design Calculations · O-Ring

O-Ring Gland Calculator

Enter a diameter → get the O-ring and the groove dimensions

Input = piston outside diameter. The cylinder bore is derived: piston + clearance E.
Decimal comma or point both work. The rest is calculated automatically.
Static: no moving contact. Dynamic: reciprocating (piston or rod moves).
Selects temperature/chemistry guidance and typical Shore A. Geometry stays the same (silicone: smaller clearance).
Used for the backup-ring advice and groove widths G1/G2 (Parker Design Chart 4-2 / 5-2).
Enter a diameter to see the cross-section
—
Material —
Inside Ø
—
Cross-section
—
Outside Ø
—

Key groove dimensions

Enter a diameter: the key dimensions appear here.
How to use the iLogic export Print and CSV are free · Auto-groove package €5 (demo, no real payment) → zip with iLogic rule, STEP, CSV and PDF
Details: all dimensions, material, surface finish, alternative and sources

Groove dimensions

—

Design aid only. Check the dimensions against the O-ring supplier's data before production.

O-ring groove FAQ

How big is the O-ring groove for a 63.5 mm piston?

For a static piston seal in NBR the calculator picks AS568-228 (56.74 × 3.53 mm). The groove gets a diameter of 57.925 mm (tolerance −0.051 mm), a width of 4.75 mm, a depth of 2.788 mm and a radius of 0.25–0.64 mm. The ring stretch is then 2.1 %.

How much squeeze and gland fill should an O-ring groove have?

In the 63.5 mm piston example the squeeze is 19.4 %, against a Parker range of 16–23 % for static seals. The gland fill is 71.5 %, inside the 60–85 % band (optimum 75 %). Because of the 2.1 % stretch the cross-section becomes slightly thinner, so the effective squeeze is 18.0 %.

How do I calculate an O-ring groove in a bore?

Select Bore and enter the housing bore diameter; you can also enter the rod diameter. For a 50 mm bore (static, NBR) the calculator gives AS568-135 (48.89 × 2.62 mm): groove diameter 54.077 mm, width 3.556 mm, depth 2.038 mm and a squeeze of 20.4 % (range 17–24 %).

When do I need a backup ring?

Static seals need no backup ring up to 103.5 bar (1500 psi) according to Parker Design Table 4-2. Above that the calculator advises one: at 200 bar static on the same 63.5 mm piston that is 1 backup ring, and the groove width becomes 5.283 mm instead of 4.75 mm. For dynamic seals the calculator uses its own rule of thumb of 500 psi (about 34 bar); that is not a Parker table value.

Which standard does the calculator use: AS568 or ISO 3601?

You choose AS568 or ISO 3601. The calculator looks for a standard ring with 0–5 % stretch at your diameter. If none fits, it says so and you can consider a custom ring.

The figures come from the calculator above. Always check the dimensions with your O-ring supplier's data.