Design Calculations · Fitting

Hydraulic fitting identification

Measure the thread and seat → get the likely standard and size

Male: measure over the crests. Female: measure the smallest diameter in the bore. For inch: decimal, e.g. 0.5625.
TPI = threads per inch. You may leave it empty, but the result is less certain.
mm
Helps with 24° fittings (L or S) and with JIC/ORFS.
—

Candidates

Fill in the diameter: the candidates appear here.
Print and CSV are free.
Details: method, tolerance and sources

The tool compares your reading with the nominal major diameter (for a female thread: the minor diameter) and the pitch of every size in the table. A difference of 0.3 mm (caliper uncertainty) counts as one standard deviation; 0.5 mm on tapered threads. The pitch must match within about 2 %.

The seat or seal counts if you enter it. A wrong choice lowers a candidate strongly but does not remove it. 37° and 45° are hard to tell apart by eye.

Confidence: high ≥ 70, medium ≥ 35, low below that (score 0–100). Without a pitch the score never goes above medium.

BSPP and BSPT have the same diameter and pitch: the difference is the form (parallel or tapered) and the seal. JIC and SAE ORB share the same thread.

Sources

  • BSP: ISO 228-1 (G) and ISO 7-1 / EN 10226-1 (R), major diameters and TPI; ISO 1179 for the stud ends.
  • NPT/NPTF: ASME B1.20.1 and B1.20.3; outside diameter = pipe OD (REMS thread tables, Engineering ToolBox).
  • JIC 37°: SAE J514 / ISO 8434-2; SAE 45°: SAE J512; SAE ORB: SAE J1926 / ISO 11926 (Hydraulics Direct thread chart, Brennan Thread Chart).
  • ORFS: SAE J1453 / ISO 8434-3, thread and AS568 O-ring (manufacturer tables to ISO 8434-3).
  • 24° cone: ISO 8434-1 / DIN 2353, L and S series (Adaptall, Pulsar Hydraulics).
  • Metric: ISO 261 (thread) and ISO 6149-1:2019 table 1 (port sizes).

Identification aid only. Check the fitting with a thread gauge and a seat gauge before you order or fit parts. Never mix fittings of different standards.

Examples

Three readings you can check in the tables. The button puts the same input into the tool.

Example 1: ½" BSPP

Male thread 20.95 mm, 14 TPI, no cone. ISO 228-1: G ½ is 20.955 mm and 14 TPI → G ½ (BSPP). BSPT R ½ has the same sizes but is tapered.

Example 2: 9/16-18 JIC

Male thread 0.5625 inch (14.29 mm), 18 TPI, 37° flare. SAE J514: −6 = 9/16-18 UNF → −6 JIC 37°. SAE ORB −6 has the same thread but no cone.

Example 3: M22×1.5 24°, L15

Male thread 22 mm, pitch 1.5 mm, 24° cone, tube 15 mm. ISO 8434-1: M22×1.5 is both 15 L and 14 S; the 15 mm tube gives 15 L.